@TJ 

@TJ 

Good tip. Thank you! My TJB order of parts shipped so I'll be working on it all soon. 

@TJ I have not, will do just thank and report back. thank you

@TJ Right now still removing wires and extras. I'll update as soon as I have anything meaningful to share. 

@Stephen Kemp well that shouldnt be sealed., its a very important part of your bike called the choke. you need to get a set of the shorty choke knobs on the side and thread those in. theres another...

@Bry Cox sounds like you know what youre doing! one small tweak - id rebuild the carbs, replace the intake boots and get it to run AS IS. dont use the gas tank to feed the carbs use a fuel bladder ...

@erodriguez.core have you checked a service manual? 

@juriankwist ok so either you dont have stock VT750DC carbs, or you pulled out a non serviceable part. you didnt mention the year of your bike either, but the VT750DC began in 2001 and lasted till ...

@Duo have you rebuild the caliper? you have mentioned a new brake line, and mc but made no mention of the caliper, if you were incvolved in a collision its very likely that the caliper is toast. th...

@Evan Parson i dont believe so. 

@EvilSkunk yes you can get he bike to run with the kit without stacks. you will still need to tune, i recommend replacing your paper filter with a foam element at the very least. it will make your ...

I picked up a 2001 shadow 1100 sabre ive been slowly working thru it and ive gotten to the carb there was a big port on the side that had a piece of plastic glued over it and I cant find anything t...

Hey guys. I grew up on motorycles, but new to chopping. I've been following TJ Brutal for their videos on other bikes, and decided I needed to build out my own chopper.  So yesterday I b...

My brother pulled the entire final‑drive assembly out of the swing arm tube, and now we can’t get it to slide back in far enough for the four mounting bolts to fully go into the mounting brac...

I am desperatly in need of two emulsion tubes for the honda vt750Dc dual carbs, the tubes where the needle goes in to not the jet.

If my master cyclinder is functioning incorrectly can someone please link me to a replacement part that is "Chrome" and a solid replacement that will work? 

So I'm having an issue with my brakes. So, my brake lever feels exetemely tight, like I can pull it very very little and it locks the brakes up. I have checked the caliper i can depresse it by hand...

Are the gas caps on your peanut tanks interchangeable with harley gas caps?

I'm just wondering if I can snag a set of pipes here and the carb rebuild/tuning kit and have everything I need to get my bike running properly if I will be using the stock intake. I understand tha...