I recently hard tailed my vt600 and I’m concerned I’ve somehow bent the frame. Ive taken the rear wheel off a few times since modifying the frame and everything has been fine. Went to t...
I recently hard tailed my vt600 and I’m concerned I’ve somehow bent the frame. Ive taken the rear wheel off a few times since modifying the frame and everything has been fine. Went to t...
Hi All, Im new to riding just getting my license and got an ACE 2003 Shadow for my 1st bike. Oil, new battery then cert, insurance and course upcoming too.&nbs...
Hi Everyone I am 48 and starting my life over. I rode dirt bikes non licensed on private property in my youth, not completely new to riding. I have a 2003 Shadow ACE 750. About to change b...
I'm newer to bike mechanics but I had gotten this 1994 Honda shadow vt1100. I was told it was carb issues. The carbs looked like they were set ablaze at one point. So corroded and just utterly dest...
Hey@TJ, I read through the tuning guide and removed my carb once again to restart my tuning journey. When doing so, I noticed a few things. 1) The carb boot was torn up (I ordered a new one from y...
@TJ this will probably be a dumb question but does this also go for my 1994 Honda shadow vt1100. I had gotten it off a friend who got it with mutilated wiring. As of now we're pretty sure we are go...
Hey Brutal team, I recently bought a Honda shadow 750 ace and Ive doing a lot of research about upgrades. I've read that replacing the rear sprocket with a larger one will give you faster throttle ...
I purchased the max kit for a honda 06 1100. My shop said they were having a hard time getting it tuned. Also there were six jets sgoukd we be doing somthing different or any tricks woukd be great....
I purchased the max kit for honda 1100. My shop is having trouble getting it dialed in. Wondering if there's somthing they are doing wrong. And what are the six different jets
@TJ yes it did! Ran well. And even now it idles good all until the choke goes in.
I'm thinking of buying this bike https://www.facebook.com/share/17cfhytRTC/?mibextid=wwXIfr can you guys listen to the motor and see if you can hear anything bad about it. Or just by the pi...
Are there any smaller front or larger rear chain sprockets available for VT600 anywhere? I was thinking of making takeoff with foot clutch smoother. Here is my setup, I extended the long side (an...
I need help tuning my VStar. Yes, I know this is more for Sadows and HD, but I really need the help. I change the exhaust tnds on my VStar 1100 to an open one, and I did bypass the AIS already so t...
@Lars Himpens Perhaps check the air/fuel mixture screws? Although it's hard to tell whether it's too lean or rich, given your somewhat contradictory symptoms (dies when pushing the choke in (too le...
@TJ Thanks for the reply. I followed your advice – disassembled, cleaned and greased all the moving parts and put it back together. Issue solved. No friction, no "gap", and the motor seems to...
If I install the HT Struts will I need to adjust my kickstand? It seems pretty low, but I'm asking what others are doing.
I am wondering why VT600 community keeps calling the crankshaft dual pin and using as a supporting arguement for saying it will not sound like a Harley. Correct idle speed, oil pressure, wasted sp...
@TJ Okay the battery was defect, the new one works fine now, but there is another new problem with the engine. The spark plugs are wet and black. The engine starts with the choke out, but when I pu...
I have a 2021 Low Rider S. Installed a TCBros 2-1 exhaust with the DynoJet Power Vision 3. What I didn't buy was the wide band O2 sensors. My bike runs pretty hot and I've read that installing thos...