hello there!
I'm moving all electronics (except coils and regulator) to the inside of the electronics tank, do I need to insulate the tank interior for short circuits / components rattling etc?
Also, by moving the coils to the back of the tank, I would need extended ignition wires - where can I get those? or can I extend the wires myself?
Thanks!
@Marcelo Pham i usually tape a small section of styrofoam hose over my starter relay so the contacts dont touch the inside of the tank.
For the coil relocation i use my ignition tune up kit, its got 10 feet of ignition wiring, plugs and resistor caps to get you all set for success. heres the link - https://shoptjbc.com/products/ignition-wire-and-resistor-cap-set?_pos=1&_sid=d3ead6114&_ss=r
hey man @TJ Brutal
awesome - another question though - using your ignition wire, how do I extend it? just cut the original cable above the cap that goes to the coil, then patch there? Because not sure how to "reproduce" the part that connects inside the coil
thanks!
@Marcelo Pham watch the video dude! shows you how to do it - https://youtu.be/_U0XheccdJE?si=axVzu0vT9bnhCq50
@TJ Brutal oh man I missed that video, thanks!!
no problem @Marcelo Pham i got you!
