Curved Bobber Fender - Honda Shadow - Fits Rear Tires 160-170

Our Curved Bobber Fender for Honda Shadow stock tires is great for getting that bobber, or chopper rear end look for your Honda Shadow! Handmade of 13 ga steel, this is a fender built to last! These hand made fenders fit a 160-170 tire perfectly, and they will fit most 180 tires, depending on the brands tire profile, the fit may be more snug than others.

This TJ Brutal Customs bobber fender does not include any hardware.

These rear fenders offer a closer profile than the flat top fenders! They require some fabrication to mount as they do not have any holes pre-drilled, so break out the welder and hood!
These are approx. 7" wide and 23" long and when mounted to a stock frame they extend about 4" past 12 o'clock on your wheel.
They fit the rear wheel like a glove and are strong enough to carry a passenger, a sleeping bag and tent, or a drill press! Yes, we've done that! 

The easiest way to set these up on a Honda Shadow VT600 that has been hard tailed:  Lay a length of bike chain down the center of your tire to set fender height. You can use angle brackets welded to the swing arm or our Pressio fender mounting kit. Drill holes in fender to bolt fender to angle brackets or pressio kit. Drill 5/16' hole in axle plate. Tap with 3/8-16" tap. Bullet bungs get welded to top of struts and countersunk bungs get welded to bottom of the struts (cut struts to desired length). Cap head bolt goes into countersunk bung into axle plate and bullet bung gets bolted to fender from inside fender.

For pre-03 750 models you can use the L brackets to mount to the frame and any other supports would need to be of your own design.