@Eelco Scholten what kit are you looking at? can you drop a link?  

@Eelco Scholten congratulations man!!! a few things that will help you successfully resurt this Honda Shadow barn find gem - First, pull one plug from each cylinder and you can spray wd-40, or...

@Karl Valderhaug hahah! happens to the best of us when we are hittin those garage beers and workin on a chopper! 

@Karl Valderhaug Hell yeah man! Thank you! If you get a second, leaving a review helps other riders out! Thanks again dude! Enjoy! 

Just wanna share a few pics, for any of you considering theese stainless steel Boot burners..  i was i awe the second i opened up my box from TJ.. holy shiet they are gorgeous!! 

Haha offcourse.. feel kinda stupid now but to my defence i was 12 cans down and could barely see straight.. Got the new one in now 👊🏻

@TJ appreciate it my man!

I'm picking up mine next week... After watching TJ on YT my choice was made. Got one from 91 (europe) but manufactured 88/2 (according to the sticker on the bottom tube). Fisrt owner and only ran u...

I'm pretty new here so i might have missed it... I was looking at the performance kit for my VT600. But it only comes with the black stacks? There's no option to choose the Brass ones? 

My 07 Saber 1100 with current and hopefully soon to be short shots from TJBC

@Reuben Shelton if you run a +2 springer, you will likely not notice a ride height difference. you have to remember a springer puts the axle out in front of the neck line and the axle is also above...

@Brady Posey The hose you are touching is the vacuum line that would actuate the AFP built into the petcock. you need to put a good vacuum cap on it so you dont get a vacuum leak. you will no longe...

@Karl Valderhaug That good sir is your needle jet! That goes in the carb body before you put the main jet holder and main jet back in. It is directional too. One end will be kinda flat with a hole,...

@Griffin Pedigo Excellent suggestions dude! 

@Marcelo Pham i usually tape a small section of styrofoam hose over my starter relay so the contacts dont touch the inside of the tank. For the coil relocation i use my ignition tune up kit, i...

I just had this happen the other day when I rebuilt my carbs. If everything else is good and you can jump it, it's your ignition switch!  Steps to fix: 1. Pull off the bottom half of the ign...

Ok i might be an idiot right now..  im done with the carb, and stuck with this.. what is this for? 🙈 

@Marcelo Pham hey man we have done several runs of the slide covers. but they never moved, i ended up taking 3 years to sell 30 sets. we may do a pre-order fro them, but to do a full production run...

hey are you going to fabricate these? would love for my single carb   Thanks!

hello there! I'm moving all electronics (except coils and regulator) to the inside of the electronics tank, do I need to insulate the tank interior for short circuits / components rattling etc...