Just so I know what the talk is about the term slugging the tubes meant taking a 2 inch long piece of pipe and compressing the fork springs further down, extending the tube. Ive never heard ...
Just so I know what the talk is about the term slugging the tubes meant taking a 2 inch long piece of pipe and compressing the fork springs further down, extending the tube. Ive never heard ...
Yank them carbs and sonic cleam them, your idle ports are clogged.
Changing heat ranges useually has to do with fuel type. E85 needs hotter plugs, 93 octane should not. When I used to race I bought pistons by the case. Would burn quarter sized holes in the ...
Clean them carbs and top teir 93 or better, depending where you live.
Idle circuit is plugged, yes in brand new carbs there is crust inside some carbs. Stripper down and sonic clean them. Make sure you clean all the tubes. Check the water when done, you will s...
If they dont say, I take it as stock, silly me. Been racing since the 60s and do not ever mis-match tires. I hit the ground at 135mph once. ONCE was enough. (front tire blew)
Screw them all the way in, if it runs it is getting air from somewhere else, bad gaskets or cracked body.
The gear package in the 883 is better for zipping right along.
There is a 79 Iron Ive been looking at in CL in Seattle. Id have it, cept 3 grand for sepic, a grand for the garage door, and property tax next month.... Not a good time to be buying anothe...
We used to weld a onch inch square hunk of steel to the bottom of the kick stand. Callemed "Clubfoot". Back when they made steel kick stands that could be welded on. Get a longer cable, might hav...
Its all about weight. You are never sposed to mix tires, never ever. Your front and rear wheel are fighting each other. Bias ply and radial mixing can be deadly. Rear 160/80s-15 Front 120/90s- 1...
I found a complete gasket set on craigs list for $50. I also got everything CB he had. Oh yeah you would have to cut that one in half, this one only a Johnny Popper.
https://www.youtube.com/watch?v=312XwcRLbXQ On the battery thing. My service manual says 2 hours flate rate to R&R the battery in my 2020 Slim. Them builders have nothing on the factory...
Ive been doing carbs for decades, the only thing Ive ever used in our sonic cleaner is Simple Green Aircraft Grade. Ive done carbs going back to the 1920s ones, with no discoloration of the ...
@Smeltie A blown head gasket is what's the problem. I'm good, but not that good :-D
With Glory comes pain. Thats why we get up and do it again. The only times in the last 50 years Ive gone to a hospital, its been in leathers. Along with your new found wide eyes, use them to see ...
Since springs came up in another post, Id like to tell the tale of my seat spring adventure. I am a big guy, maybe even bigger than TJ. When I converted form a two up seat to a 1936 Harley ...
from yer shop Dude, can you give me the center to center diameter so I can see if it fits my machine. Overall diameter also. Might even put them on the sell page.
I build cafe racers, like bobbers they are not the most confortable rides out there. I had to sell my last one fore my knees gave out. I chop everything up, but then I saw Easy Rider in the ...
Springs, guilty. I looked at the stock solo seats (no springs :-) Get one, take to an seat shop and have them modernize it. Gel pads are your friend. I did a UM 650 seat for a gal. Being a...