I had to put the aluminum duct tape on my plastic electronics cover because the exhaust melted the corner of it
I had to put the aluminum duct tape on my plastic electronics cover because the exhaust melted the corner of it
The picture with me holding the screwdriver I am pointing to the cap over the vacuum port
Thanks for responding. I definitely don't have the slide vents blocked. I still have the factory hoses setup on them. The ports I have blocked went to the air box.
The only 2 ports that I have plugged are the 2 at the left and right of the carburetor intake that join and t into the one hose that goes to the air box. I still have the slide diaphragm vent ...
Having similar issues on my 01 750. I'd start with checking float making sure the needle and seat is seating properly. On mine it was when I had carbs off and blowing through a hose but when on the...
How much does adding fork extension change the handling. Are you giving up better low speed handling and maneuverability for better high speed stability. Or does it really matter? Can you change ho...
Before I start taking everything off and back to stock I guess my only option to try is to wrap my exhaust. So I am going to try it hopefully it will work well enough for me to get some use out of ...
I have installed the max performance kit on my 01 Shadow ace 750 dual carb. Got it jetted and shimmed and adjusted for a little bit but once the engine warms up it starts running rich and loads up ...
So upon further investigation I am discovering that my issue is heat soaked carburetors. After the bike dies and if I get close to the intake on the carburetor for the front cylinder I can hear it ...
I pulled the baffles it started a lot quicker I can feel the difference holding my hand over the velocity stacks. I got the idle mixture adjusted it ran for maybe 10 to 20 minutes and same thing on...
@Terry Walters thanks for the well wishes. I think I will pull the baffles out of the exhaust and see if it is any happier without the restrictions in the exhaust. It seems to me like it's vapor lo...
I have had enough. Have been going in circles for over a month now trying to get the max performance kit to work. I have tried several combinations and still end up in the same place. Third set of ...
Got home pulled the baffles turned on the fuel tried to start it and raw fuel puffed and spit from the rear cylinder. So tomorrow will pull the carbs and change the needle and seat agai...
I still can't get it right. I'm on my second set of boots and second set of bowl gaskets. I have 42 pilots and two shims on needles and 145 mains. My floats are at 10mm. My low speed is still too r...
About a year ago sister in-law gave me a Honda Shadow ace with 18k miles on it. Her spouse was a one percenter so they were deep into bikes. They got the Shadow for her to learn to ride then he got...
Got the max performance kit and wanted 4" baffles but were out of stock so I cut three inches off the 8" set for exhaust. Have had to pull the carburetors off so much that I can do it and change je...
