Malleus Machined Motorcycle Grips - Throttle Sleeve & Clutch Grip For 1" Bars

$ 99.99 $ 149.99
| /
The Malleus Machined Grips for Honda Shadow are the perfect choice for your bobber or chopper build! The throttle sleeve tube fits...

The Malleus Machined Grips for Honda Shadow are the perfect choice for your bobber or chopper build! The throttle sleeve tube fits most throttle cables and stock honda shadow switch housings and the clutch side grip and throttle sleeve tube will work with all 1" handlebars.
The Malleus Machined Aluminum Throttle Sleeve and Clutch Grip set is the most simple way to set up your handlebars, no need for grips that will wear out or need replacing! The throttle sleeve and clutch side grip are machined from 6061 Aluminum and anodized with beautiful knurling, not too extreme, just enough to provide a solid hold!  I always hated when grips were knurled to the point of aggressively shredding my palms!! Not so with the Malleus Grip Set! The throttle sleeve fits perfectly in our Acerus Throttle Assembly 

The matching clutch side grip simply slides on and attaches to the handlebar with 3 included #10-32 set screws, we recommend using a bit of red loc-tite on each screw . Some folks like to add a dab of glue when sliding the clutch side grip on, but we have found it's not necessary.

The throttle sleeve is meant for single cable operation. It is not meant to run the push cable. You do not need the push cable, remove it and enjoy your newfound throttle performance!! 

Fits 1" handlebars
Fits the following models throttle cables - 
Honda Rebel
Honda Shadow VLX600 / VT600
Honda Shadow VT750, ACE, Aero, Spirit, Phantom, RS
Honda Sabre
Honda Magna
Honda VT1100
Honda VTX
*May fit other metric bikes.

While this part doesn't need grips, you can leave the clutch side grip off and use a traditional set of rubber grips. A rubber grip set will fit over the throttle sleeve. 

We recommend using a tiny bit of red thread-locker on the set screws of the clutch side grip. 

You will need to dremel or file off the locator nipples on the lower half of the start/kill switch housing. Dont dry to drill another hole in the bars. This locating nipple is there so that every bike rolls out of the factory the same. It has nothing to do with the clamping effect of the housing. 

Description

Customer Reviews

Based on 7 reviews
86%
(6)
14%
(1)
0%
(0)
0%
(0)
0%
(0)
T
Tim Campbell
Feeling handsy with my brass

Handgrips are great and high quality. Was a little worried about comfort at first but they are actually much more comfortable than thought and look badass! Easy install with included set screws.

C
Customer

Great product 🤙🏿

J
Jermaine

Well crafted handlebar grips that looks and feels great

j
john
Great quality, good price, shipped fast.

Great quality, good price, shipped fast.

W
Will
Awesome company that knows how to take care of riders

I just bought a bike (my first bike) on Christmas eve that has several TJ brutal parts on it and in the few miles that I've owned it the set screws backed out of the clutch side handle due to the previous owner not using loctite on the screws and my over excitement to just hop on and ride while the winter weather was warm. Sent an email to these guys about the issue I had and they sent replacement screws even though the set screws falling out was my fault and I wasn't the original buyer of theses grips. In my opinion they went above and beyond to take care of me and get my bike right again. 10/10 would recommend TJ Brutal parts and I'm definitely looking forward to doing business with them in the future.